Fara í efni

Karfan þín

Karfan er tóm.

VNR.: KE-KATWH

Keeley Katana Clean Boost Throwback White

Samtals m/vsk
41.990 kr.

Our Katana Clean Boost is back and better than ever! Redesigned while going back to our roots.
We listened to what our players wanted and went back to our roots. The new Katana uses the original JFETs that made the original so special. We used the same component values from the original Katana, and updated the Boost mode to offer a more robust, clear sound, giving more clarity to bass notes when engaged. We updated the build with modern construction techniques to make this Katana the most dependable Clean Boost on the market, including an updated aluminium control knob, designed to be adjusted on the fly.

Framleiðandi audiodistribution
Samtals m/vsk
41.990 kr.

Nánari lýsing

WANT A MIRROR IMAGE OF YOUR TONE, ONLY LOUDER? Roll the volume knob forward with your foot and you’ll be good to go! NEED EVEN MORE? The Katana Boost is also a fat, harmonically rich boost, just pull out on the volume knob and push the limits with overdriven tone! You can keep it on all the time to push your amp harder, or as an occasional boost to cut through the mix.

The Katana circuit is Robert Keeley’s first guitar effect design for Keeley Electronics. It was originally designed as part of the Time Machine Boost, but then became an independent product under the Keeley name after the release of the original Keeley Compressor.

 

WE ARE PROUD TO OFFER YOU THE BEST KATANA EVER.

 

 

Two modes, Pure Clean and High Gain

1. With the speed knob Pushed In, think of it as a volume control that goes to 20.

2. With the speed knob Pulled Out, it’s a cutting boost with a bit of gain. Not quite an overdrive, just overdriven tube grit and edge to your tone.

 

The Katana Clean Boost offers two modes. Pull the control knob for extra +30db Boost – It will make your signal sing!

 

Voltage Doubling

Dual FETs for the most tube like tone in a transistor design. Power Doubling on the inside so you put 9VDC in, and we use a charge pump to nearly double operating voltage! (Caution – 9 Volt DC Maximum Input Voltage (don’t try to put 18 volts to the unit hoping that the doubler will make it 36VDC!)

What do higher power supply voltage rails mean?! -> SUPER CLEAN HIGH-HEADROOM BOOST! Pull the Level knob out to switch -> Tube-like gain! THE EDGE!!!!

 

The Katana circuit is Robert Keeley’s first effect design for Keeley. As far as clean boosts go, the Katana is KING TONE!

 

The Katana’s push/pull volume control is conveniently located on the side of the pedal for on-the-fly foot adjustment.

 

 

Instructions:

You may also like…

Nýlega skoðað

Effekta pedalar - Fleiri vörur

Nýtt

Behringer Octave Divider

Samtals m/vsk
19.990 kr.
Á lager
Nýtt

MXR Wylde Audio Phase

Celebrate the 20th anniversary of the explosive collaboration between Dunlop and Zakk Wylde with the MXR Wylde Audio Phase. This pedal adds dimension and dynamics to Zakk’s legendarily blazing solos and razor sharp leads—all with the twist of a single Rate knob. Take it from a slow grind to a jack hammering pulse, or use it as Zakk does, at the 9 o'clock position for a slow burning sweep.
Samtals m/vsk
22.990 kr.
Á lager
Nýtt

MXR TRS Split & Tap

The MXR Split + Tap is a compact footswitch that combines a passive TRS splitter with a responsive tap tempo control, all in a single compact-yet-robust unit. Want to direct your sound to two different places, like separate amplifiers or recording equipment? Are you looking to combine two signals into one? The Split + Tap has you covered thanks to a TRS input and Left and Right outputs, all passive, allowing you to split your TRS signal to mono L/R paths or combine stereo L/R paths into a TRS path. The Split + Tap also allows you to adjust the timing of your effects or toggle their parameters on the fly with a momentary switch that responds quickly to your touch. Get the MXR Split + Tap for versatile signal setups and dynamic performances.
Samtals m/vsk
11.590 kr.
Á lager
Nýtt

Pedaltrain Classic 3 in Tour Case

Pedaltrain Classic 3 offers a 24” x 16” (61cm x 41cm) pedal board with five rails, traditional spacing, and an elevated mounting surface. You’ll be surprised at the new and interesting pedal configurations you can achieve with this model. Classic 3 is compatible with our VDL-MK and True Fit Universal Brackets. There is plenty of room underneath for organizing cables, mounting power supplies, direct boxes, and other accessories. This model is also available with a soft case.
Samtals m/vsk
53.990 kr.
Á lager