VNR.: KE-MK3DR

Keeley Electronics Mk3 Driver

Samtals m/vsk

41.990 kr.

The Mk3 Driver – Andy Timmons Full Range Overdrive is an overdrive workstation that allows you to orchestrate everything from a clean boost to a treble supercharger, a chimey tube-amp overdrive to a square-wave, germanium fuzz generator and more. This pedal combines a three-control blues driver circuit with two switches for the voicing Drive and Tone characteristics. Robert and Andy developed these switches to give players a broad range of drive tones. The Drive toggle engages two germanium diodes for a smoother, slightly compressed drive. Switch to Andy’s clipping style for a brighter and more articulate attack. Every part of the circuit has been optimized for tone and the demanding needs of a recording and touring artist such as Andy Timmons. Simply adding the Mk3 Driver to your pedalboard will likely make your rig sound better. This pro sounding overdrive can be switched between true-bypass and buffered bypass at any time.

Classic blues driver circuit with decades of Keeley mod experience
Germanium based overdrive crafted with Andy Timmons’ direction
AT/RK Tone Switch cuts lows for a clarity or boosts low-end for power
AT/RK Drive Switch alternates between asymmetrical silicon to dual germanium diodes
Buffered Bypass or True-Bypass – Change instantly depending on your rig’s needs
JFET Transistors, Germanium Diodes and Op-Amp Gain combine to form harmonically rich overdrive
9 to 18 Volt operation for huge dynamic range and headroom

Framleiðandi audiodistribution

Fjöldi

Samtals m/vsk

41.990 kr.

Nánari lýsing

Andy Timmons – Tone Switch

The Mk3 Driver gives you two tone control circuits to choose from. When the Tone Switch is up and in the AT Position the tone control features Andy’s preferred voicing of the low-end response of a drive pedal. Each note in a chord is clear and articulate. If the Tone Switch is down and in the RK Position that features the legendary Phat Boost in the low-end frequency response, perfect for pushing vintage or single coil pickups.

Full Range Overdrive – Germanium Toggle Switch

The Mk3 Driver circuit combines JFET saturation, diode clipping, and op-amp clipping in order to create its harmonically rich tone. Drive Switch UP for AT Clipping – this mode features asymmetrical LED diode clipping and is Andy’s Super AT Mod sound. When the Drive Switch is Down for RK Clipping – the circuit features two germanium diodes for clipping. This mode can sound a bit like a vintage fuzz pedal with a softer, smoother feel.

Mk3 Driver – Both Buffered Bypass & True-Bypass

The Mk3 Driver features our precise buffer for noise-free switching. We have developed a buffer which not only makes your rig sound better, it gives you silent switching with no tone loss. Switch between true-bypass and buffered on the fly. Simply press and hold down the foot switch for two seconds and the pedal will switch between true-bypass and buffered bypass! You can decide what works best in your rig.

Made In The USA – Mk3 Driver – Andy Timmons Full Range Overdrive

We design, engineer, and manufacture the Keeley Electronics/Andy Timmons Mk3 Driver in Oklahoma City. Everything about the Mk3 Driver is geared towards the professional musician and their quest for an inspiring tone when performance demands it. From the inside of the pedal and its meticulously built circuit boards to the newly fabricated aluminum enclosure – we make guitar effect pedals like finely crafted musical instruments.

Behringer Bass Brassmaster Fuzz

If you’ve ever wanted to give your bass or guitar tone an aggressive edge with a healthy amount of distortion but still retain its clarity and definition in a wall of sound, then the Behringer BASS BRASSMASTER FUZZ can deliver the goods! Fire it Up! BASS BRASSMASTER FUZZ brings a hidden gem of a circuit back to life. From subtle to completely explosive, this box packs a punch. This once overlooked vintage fuzz ciruit is now getting a whole new lease of life. Controlled Chaos Controls on the BASS BRASSMASTER FUZZ allow you to adjust how much of your clean sound is mixed in (BASS VOL), fuzz mix (BRASS VOL) as well as the amount of fuzz distortion (SENSITIVITY). Play around with these knobs combined with the BRASS and HARMONIC toggle switches and you can create some really cool fuzz tones that work super well with bass, guitar or a nice baritone! Ready for Anything BASS BRASSMASTER FUZZ is a super cool and versatile fuzz pedal where you can really dial in the perfect tone whether you’re playing some awesome classic rock or sludgy doom metal. Its robust housing can withstand a life of constant gigging and the heaviest of stomps. Get a Behringer BASS BRASSMASTER FUZZ from your nearest distributor today!

Samtals m/vsk

14.990 kr.

Á lager

Fender Santa Ana Overdrive V2

Santa Ana V2 is a JFET-based class-A overdrive pedal running at 18V internally — a design that provides the touch sensitivity and high-headroom drive that players expect from a Fender tube amp pushed hard and then some. At its heart, this dual-voice drive circuit sports three straightforward controls and a Voice switch to push your guitar from natural-sounding tight overdrive (voice A) to smooth, thick lead tones (voice B). The Drive and Tone controls provide a wide range to dial in just the right flavor of gain and treble presence in the drive signal, while the rear-mounted Tight switch pulls some pre-drive bass frequencies out for an even more focused feeling drive. To further sculpt the frequency response of your drive, a standalone, independently switchable 3-band EQ circuit is built around the Santa Ana V2 drive engine. Active Bass, Middle, and Treble controls offer a wide range of adjustment, cutting or boosting each frequency range with a center detent to mark flat response. Determine exactly how the EQ circuit interacts by using the EQ Placement switch to stack the EQ before or after the drive: Pre-drive EQ flavors the overdrive’s response by determining which frequencies are clipped most by the drive circuit; post-drive EQ lets your guitar hit the drive head on and shapes the resulting gain tones for a more dramatic EQ effect. With a fine-tuned JFET drive engine, independent EQ circuit, conveniently switchable buffered and true bypass modes, and multiswitch enabled footswitches for momentary and latching activation, the Santa Ana V2 is an ultra-flexible, intuitive overdrive with tons of tones on tap.

Samtals m/vsk

29.990 kr.

Á lager

Fender Pugilist Distortion V2

The Pugilist V2 is a distortion pedal like no other, wielding dual independent distortion engines packed inside one chassis to crank out a wealth of thick tones. Each distortion engine can be turned on separately using its designated footswitch and dialed in using its own Gain, Tone and Level controls. This provides two distinctively flavored distortion voices, with Engine A delivering treble-rich lead drive tones and Engine B laying on thick, heavier distortion. The real magic of Pugilist V2 is in the Path switch, which runs the two distortion engines through three different signal paths as they push each other into harmonically rich saturation. The two Series Modes send one circuit into the other for stacking drive tones that can be layered like amp channels, using the footswitches to kick into the next level of cascading distortion. Parallel Mode delivers deep tone-shaping by running the two engines side by side to be blended and balanced using the level controls to create the perfect meld of articulate, chunky distortion. Featuring global Mid Cut and Bass Boost switches, conveniently switchable buffered and true bypass modes, and multiswitch enabled footswitches for momentary and latching activation, these ever-sparring distortion circuits knock out huge distortion tones with modern conveniences fit for any board.

Samtals m/vsk

29.990 kr.

Á lager

Fender Pelt Fuzz V2

The Pelt V2 is a pro-level fuzz pedal with a classic spirit. Built around silicon transistors and a buffer-friendly input stage, it packs all the fuzzed-out tones a saturation-lover could ask for — from full, biting octave fuzz to smooth, harmonically rich walls of gain. Beyond traditional Fuzz, Tone and Level controls, the Pelt V2 takes saturation shaping to the next level with Sag and Bloom controls to fine tune exactly how your signal breaks and splatters into furry, gain-ladened madness. Use the Mids and Thick switches to deliver extra EQ shaping for mid and bass frequency presence to instantly push into new characters of fuzz. The Octave (Chaos) footswitch takes this fuzz into all-new territory by adding a traditional octave-up effect or, with Chaos engaged, an asymmetrical octave effect for glitchy, sputtering artifacts and unpredictable tonal chaos. To top it off, this buffer and bass friendly pedal features a Blend control that enables mixing of fuzz and clean tones (perfect for bass) or blending fuzz with the drive tone of pedals before it in your signal chain. Featuring conveniently switchable buffered and true bypass modes, multiswitch enabled footswitches for momentary and latching activation, and a world of tone-shaping tools for dialing in the exact fuzz you’re after, the Pelt V2 is the ultimate way to add a gloriously wooly coat to your tone.

Samtals m/vsk

29.990 kr.

Á lager