Fara í efni
Endurheimta lykilorð Nýskráning

Karfan þín

Karfan er tóm.

VNR.: CIOKS-1533

Cioks 3-way Daisy Chain Flex 1

Samtals m/vsk
1.390 kr.

3-way daisy chain Flex – type 1

Framleiðandi cioks
Samtals m/vsk
1.390 kr.

Nánari lýsing

This Flex cable makes it possible to power three pedals using only one outlet of the power supply. You need to make sure that the three pedals can all be powered by the same voltage and that they all use the most common 5,5/2,1mm centre negative DC plug, the BOSS standard. On this daisy chain the first DC plug is 50cm from the plug which goes into the power supply’s outlet. There’s 30cm in-between the first and the second DC plug and also 30cm in-between the second and third DCplug. The total length of this special Flex cable is approx. 110cm. The longer distance between the plugs gives you more freedom in placing the pedals you’d like to power with the daisy chain on your pedalboard.

When using the daisy chain Flex make sure that the sum of the three pedal’s currents in mA stays below the max. current rating of the outlet used. Please also note that the daisy chain Flex cable has all three DC plugs connected in parallel to the power supply’s outlet. To avoid noise issues we recommend using the daisy chain Flex with analogue pedals only. This is to avoid the risk of a digital pedal introducing noise into your guitar signal when being powered in a parallel connection with a simple analogue pedal.

Nýlega skoðað

Effekta pedalar - Fleiri vörur

Nýtt

Fender Santa Ana Overdrive V2

Santa Ana V2 is a JFET-based class-A overdrive pedal running at 18V internally — a design that provides the touch sensitivity and high-headroom drive that players expect from a Fender tube amp pushed hard and then some. At its heart, this dual-voice drive circuit sports three straightforward controls and a Voice switch to push your guitar from natural-sounding tight overdrive (voice A) to smooth, thick lead tones (voice B). The Drive and Tone controls provide a wide range to dial in just the right flavor of gain and treble presence in the drive signal, while the rear-mounted Tight switch pulls some pre-drive bass frequencies out for an even more focused feeling drive. To further sculpt the frequency response of your drive, a standalone, independently switchable 3-band EQ circuit is built around the Santa Ana V2 drive engine. Active Bass, Middle, and Treble controls offer a wide range of adjustment, cutting or boosting each frequency range with a center detent to mark flat response. Determine exactly how the EQ circuit interacts by using the EQ Placement switch to stack the EQ before or after the drive: Pre-drive EQ flavors the overdrive’s response by determining which frequencies are clipped most by the drive circuit; post-drive EQ lets your guitar hit the drive head on and shapes the resulting gain tones for a more dramatic EQ effect. With a fine-tuned JFET drive engine, independent EQ circuit, conveniently switchable buffered and true bypass modes, and multiswitch enabled footswitches for momentary and latching activation, the Santa Ana V2 is an ultra-flexible, intuitive overdrive with tons of tones on tap.
Samtals m/vsk
29.990 kr.
Á lager
Nýtt

Fender Pugilist Distortion V2

The Pugilist V2 is a distortion pedal like no other, wielding dual independent distortion engines packed inside one chassis to crank out a wealth of thick tones. Each distortion engine can be turned on separately using its designated footswitch and dialed in using its own Gain, Tone and Level controls. This provides two distinctively flavored distortion voices, with Engine A delivering treble-rich lead drive tones and Engine B laying on thick, heavier distortion. The real magic of Pugilist V2 is in the Path switch, which runs the two distortion engines through three different signal paths as they push each other into harmonically rich saturation. The two Series Modes send one circuit into the other for stacking drive tones that can be layered like amp channels, using the footswitches to kick into the next level of cascading distortion. Parallel Mode delivers deep tone-shaping by running the two engines side by side to be blended and balanced using the level controls to create the perfect meld of articulate, chunky distortion. Featuring global Mid Cut and Bass Boost switches, conveniently switchable buffered and true bypass modes, and multiswitch enabled footswitches for momentary and latching activation, these ever-sparring distortion circuits knock out huge distortion tones with modern conveniences fit for any board.
Samtals m/vsk
29.990 kr.
Á lager
Nýtt

Fender Pelt Fuzz V2

The Pelt V2 is a pro-level fuzz pedal with a classic spirit. Built around silicon transistors and a buffer-friendly input stage, it packs all the fuzzed-out tones a saturation-lover could ask for — from full, biting octave fuzz to smooth, harmonically rich walls of gain. Beyond traditional Fuzz, Tone and Level controls, the Pelt V2 takes saturation shaping to the next level with Sag and Bloom controls to fine tune exactly how your signal breaks and splatters into furry, gain-ladened madness. Use the Mids and Thick switches to deliver extra EQ shaping for mid and bass frequency presence to instantly push into new characters of fuzz. The Octave (Chaos) footswitch takes this fuzz into all-new territory by adding a traditional octave-up effect or, with Chaos engaged, an asymmetrical octave effect for glitchy, sputtering artifacts and unpredictable tonal chaos. To top it off, this buffer and bass friendly pedal features a Blend control that enables mixing of fuzz and clean tones (perfect for bass) or blending fuzz with the drive tone of pedals before it in your signal chain. Featuring conveniently switchable buffered and true bypass modes, multiswitch enabled footswitches for momentary and latching activation, and a world of tone-shaping tools for dialing in the exact fuzz you’re after, the Pelt V2 is the ultimate way to add a gloriously wooly coat to your tone.
Samtals m/vsk
29.990 kr.
Á lager
Nýtt

Fender Bends Compressor V2

An intuitive compressor/boost combo offering low-noise compression in both modern and vintage tube flavors, the Bends V2 is ideal for guitar and bass alike. Utilizing a unique take on OTA technology for real-time gain control, this compressor reacts to your playing dynamics smoothly and naturally to balance the volume of louder and quieter sections while adding sustain and thickness to your notes. The Bends V2 simplifies compression to three clearly labeled controls — a three-speed Attack switch, a fine-tuned Release control, and an Input control which sets the input level of the compression trigger. An active Tone control with a center detent cuts or boost treble to make up for any lost sparkle, and the Blend control injects clean into the mix to provide the perfect balance of clean dynamics and compression. A rear-mounted Vintage switch provides the real secret sauce, reshaping the circuit from a crisp, surgical action to a beautifully colored smooth compression with a hint of natural saturation when engaged. Combine boost and compression for some real magic. The Comp Pre/Post switch rearranges the internal circuit to reorder the independent ultra-clean boost and compression. Place the boost before compression for soaring Nashville-style sustain or stack the boost after your signal is compressed and kick it on for a solo boost to increase the overall output level into your next effects. Featuring an independent boost circuit, switchable buffered and true bypass modes, and multiswitch enabled footswitches for momentary and latching activation, the Bends V2 is a fully featured compressor that brings natural feeling dynamic control to any instrument.
Samtals m/vsk
29.990 kr.
Á lager