VNR.: KSR-EROS

KSR Amplification EROS

Samtals m/vsk

48.990 kr.

It’s not your typical boost. It will boost clean without overdrive, add a little grit, or add distortion. It has a 3-band active EQ for precision sculpting.

Use it in front to add volume or grit to a clean or crunch channel. Or, sculpt your amp’s distortion response, as you would with a typical boost. However, you’re no longer limited to a narrow frequency range dictated by a single tone control found on a lot of classic boosts.

Similarly, use it before or after the Ceres for even more control over its tones, and in order to get the most out of it based on your power amp situation.

Framleiðandi audiodistribution

Uppselt

Senda fyrirspurn

Samtals m/vsk

48.990 kr.

Nánari lýsing

Setup Notes

This is not “just another TS style boost,” therefore it should not be setup in that way. e.g. don’t crank the Level and cut the Gain. Start with both at noon and go from there. The Feel (tight/fat/thick) and Mode (clean/clip/dirt) switches will lose effectiveness the lower the Gain control is set.

Further, the higher Level is cranked the more internal distortion can be generated in the last gain stage, and therefore it will add distortion within the Eros coupled with a higher Gain setting. With a lower Gain setting the last stage will remain unclipped, but a huge signal will slam the front end of any amp. This can be too large a signal to achieve your desired sound. e.g. too much saturation due to lack of headroom in the amp’s first stage.

In short, all the controls will interact, and there are countless ways you can run this pedal. Please experiment and share your results!!

Specifications

Controls: Gain, Bass, Mid, Treble, Level
Switches: Mode (clean/dirt/clip), Feel (tight/fat/thick)
Power: DC 9V with internal booster, >= 100 mA
Size: 4.37″ x 2.37″ x 1.22″

KMA Machines DUAL LOOP SWITCHER

We get it. There’s a wealth of pedalboard switching devices on the market and some can be quite complex, but what if you want to keep switching between multiple pedals on your board simple, easy to use and yet still effective? Well, the KMA Machines DUAL LOOP SWITCHER pedal has you covered and has been created with a focus on durability, reliability, simplicity and hassle-free operation to expand your creativity. Whether you’re looking to simply switch between two single pedals without extended tap dancing or combine and switch between two entirely separate signal chains, this helpful utility device features KMA’s active circuitry and soft switching for maximum signal integrity without compromise. Plus, with full Stereo/Dual Mono operation the DUAL LOOP SWITCHER allows for maximum flexibility.

Samtals m/vsk

23.990 kr.

Á lager

KMA Machines Active Stereo ABY

There’s nothing new about ABY boxes. They’re a very commonly used accessory and a staple part of many setups out there. But if they are so common, then (until we launched our passive Stereo ABY) why was it so difficult to find one in a stereo format that’s well built, noise-free AND affordable? This is a question we kept encountering as we use many stereo devices daily here at KMA, plus we know that a lot of users are just as mesmerised by the wide sonic worlds of stereo as we are. So, we made a killer stereo ABY switcher to use here at our workshop. In the process we found it so useful, so we decided to make the original STEREO ABY available to the world too in a pedal format. However, despite our passive boxes gracing thousands of rigs the world over, the Active STEREO ABY takes things a little further and is ideal for those who like to use the Y splitting or combining functions – at least with some signals that don’t always play nicely together, due to often differing impedances between connected devices. With KMA’s high quality active buffer, the pedal can also help eliminate level mismatches or even signal loss, if used with long cable runs. Whether you’re looking to switch or combine a Stereo input signal between two separate destinations or switch or combine two separate Stereo input signals into a single stereo output without signal loss, the KMA Machines STEREO ABY pedal is a dependable little helper for your tonal quest – the fate of your Stereo signals is in your hands!

Samtals m/vsk

23.990 kr.

Á lager

KMA Machines Active ABY

ABY boxes are not something that will set the world on fire. We know that. But what a good ABY box can do, is start a flame that’ll fully ignite your creativity, and our Active ABY pedal is a REALLY GOOD one. Expertly built, noise-free, gorgeous looks AND affordable – it just ticks all the boxes. As an additional offering to our Passive ABY box that has graced thousands of rigs the world over, the Active ABY is ideal for those who like to use the Y splitting or combining functions – at least with some signals that don’t always play nicely together, due to often differing impedances between connected devices. With KMA’s high quality active buffer, the pedal can also help with level mismatches or signal loss due to long cable runs. Whether you’re looking to switch or combine your Mono input signal using two separate outputs, switch or combine two separate input signals into one output, the Active ABY pedal is a dependable little helper for your tonal quest – the fate of your signal is in your hands!

Samtals m/vsk

15.990 kr.

Á lager