VNR.: WARM-FTB

Warm Audio Foxy Tone Box

Samtals m/vsk

23.990 kr.

The Return Of A Legend

The new Foxy Tone Box from Warm Audio is a hyper-accurate recreation of one of the most sought-after and beloved fuzz pedals of all time - used in the early seventies by legendary tone masters Billy Gibbons and Peter Frampton, and in the present day by folks like Adrian Belew, Nine Inch Nails and Beck. Covered in thick velvet just like the vintage pedal, the Warm Audio Foxy Tone Box faithfully recreates the vintage circuit and brings you the huge tone, octave-up sounds and look of the original…without having to pay crazy vintage prices!

Framleiðandi Warm Audio

Fjöldi

Samtals m/vsk

23.990 kr.

Nánari lýsing

Serious Attention To Detail

The specific components used in a pedal circuit are critical to the way that it sounds and reacts to your playing, so each Foxy Tone Box is assembled by hand using premium parts. We searched far and wide for a stash of the correct NOS (“New Old Stock”) Fairchild germanium transistors used in the original—and then paired them with germanium diodes, high-watt carbon resistors, and film capacitors to bring the fury of the vintage pedal to the present day. It’s true bypass, and it sounds like nothing else on earth!

Fuzz It Up

Just like the original, the Foxy Tone Box features controls for Volume, Sustain, and Fuzz (from “Mellow” to “Brite”), along with a switch to engage the pronounced octave effect. From mellow and subdued crunch to all-out searing fuzz and everything in between, this pedal is a virtual library of dirt encased in orange velvet!

To get started, keep the Octave switch off and roll the Fuzz to the “Mellow” side for warm, square-wave distortion. Then engage the Octave effect, crank the Fuzz to “Brite", and increase the Sustain for maxed-out, hyper-compressed tones that are barely hanging on for dear life! Electric guitar is the obvious application, but try it on synthesizers, drum machines, bass, acoustic/electric, and more. If you can plug a cable into it, the Foxy Tone Box can add character you just can’t get anywhere else.

Technical Specifications

Download Product Manual

FAITHFUL RECREATION OF THE ORIGINAL “FOXY” FUZZ CIRCUIT WITH 100% ANALOG, FULLY DISCRETE SIGNAL PATH

PREMIUM COMPONENTS USED THROUGHOUT, INCLUDING THE NOS 2N3565 GERMANIUM FAIRCHILD TRANSISTORS FOUND IN THE ORIGINAL CIRCUIT

USES CARBON RESISTORS, GERMANIUM 1N34A DIODES, AND PREMIUM FILM CAPACITORS

TRUE BYPASS OPERATION

GOLD-PLATED PCB PADS

VOLUME, SUSTAIN, AND FUZZ KNOBS

OCTAVE SUSTAIN SWITCH FOR ENGAGING THE OCTAVE-UP EFFECT

1/4" INPUT (INST) AND OUTPUT (AMP) JACKS

RED LED POWER INDICATOR

GROOVY VINTAGE ENCLOSURE COVERED IN ORANGE VELVET

POWER CONSUMPTION: 1.5MA

WIDTH: 6.5"

DEPTH: 3.75"

HEIGHT: 1.5"

WEIGHT: 1.4 LBS

Fender Santa Ana Overdrive V2

Santa Ana V2 is a JFET-based class-A overdrive pedal running at 18V internally — a design that provides the touch sensitivity and high-headroom drive that players expect from a Fender tube amp pushed hard and then some. At its heart, this dual-voice drive circuit sports three straightforward controls and a Voice switch to push your guitar from natural-sounding tight overdrive (voice A) to smooth, thick lead tones (voice B). The Drive and Tone controls provide a wide range to dial in just the right flavor of gain and treble presence in the drive signal, while the rear-mounted Tight switch pulls some pre-drive bass frequencies out for an even more focused feeling drive. To further sculpt the frequency response of your drive, a standalone, independently switchable 3-band EQ circuit is built around the Santa Ana V2 drive engine. Active Bass, Middle, and Treble controls offer a wide range of adjustment, cutting or boosting each frequency range with a center detent to mark flat response. Determine exactly how the EQ circuit interacts by using the EQ Placement switch to stack the EQ before or after the drive: Pre-drive EQ flavors the overdrive’s response by determining which frequencies are clipped most by the drive circuit; post-drive EQ lets your guitar hit the drive head on and shapes the resulting gain tones for a more dramatic EQ effect. With a fine-tuned JFET drive engine, independent EQ circuit, conveniently switchable buffered and true bypass modes, and multiswitch enabled footswitches for momentary and latching activation, the Santa Ana V2 is an ultra-flexible, intuitive overdrive with tons of tones on tap.

Samtals m/vsk

29.990 kr.

Á lager

Fender Pugilist Distortion V2

The Pugilist V2 is a distortion pedal like no other, wielding dual independent distortion engines packed inside one chassis to crank out a wealth of thick tones. Each distortion engine can be turned on separately using its designated footswitch and dialed in using its own Gain, Tone and Level controls. This provides two distinctively flavored distortion voices, with Engine A delivering treble-rich lead drive tones and Engine B laying on thick, heavier distortion. The real magic of Pugilist V2 is in the Path switch, which runs the two distortion engines through three different signal paths as they push each other into harmonically rich saturation. The two Series Modes send one circuit into the other for stacking drive tones that can be layered like amp channels, using the footswitches to kick into the next level of cascading distortion. Parallel Mode delivers deep tone-shaping by running the two engines side by side to be blended and balanced using the level controls to create the perfect meld of articulate, chunky distortion. Featuring global Mid Cut and Bass Boost switches, conveniently switchable buffered and true bypass modes, and multiswitch enabled footswitches for momentary and latching activation, these ever-sparring distortion circuits knock out huge distortion tones with modern conveniences fit for any board.

Samtals m/vsk

29.990 kr.

Á lager

Fender Pelt Fuzz V2

The Pelt V2 is a pro-level fuzz pedal with a classic spirit. Built around silicon transistors and a buffer-friendly input stage, it packs all the fuzzed-out tones a saturation-lover could ask for — from full, biting octave fuzz to smooth, harmonically rich walls of gain. Beyond traditional Fuzz, Tone and Level controls, the Pelt V2 takes saturation shaping to the next level with Sag and Bloom controls to fine tune exactly how your signal breaks and splatters into furry, gain-ladened madness. Use the Mids and Thick switches to deliver extra EQ shaping for mid and bass frequency presence to instantly push into new characters of fuzz. The Octave (Chaos) footswitch takes this fuzz into all-new territory by adding a traditional octave-up effect or, with Chaos engaged, an asymmetrical octave effect for glitchy, sputtering artifacts and unpredictable tonal chaos. To top it off, this buffer and bass friendly pedal features a Blend control that enables mixing of fuzz and clean tones (perfect for bass) or blending fuzz with the drive tone of pedals before it in your signal chain. Featuring conveniently switchable buffered and true bypass modes, multiswitch enabled footswitches for momentary and latching activation, and a world of tone-shaping tools for dialing in the exact fuzz you’re after, the Pelt V2 is the ultimate way to add a gloriously wooly coat to your tone.

Samtals m/vsk

29.990 kr.

Á lager